Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021TRANSIT-350 HD BASE, VAN CARGO EXTENDED, 3.5L ENG VIN 8, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 567 (TIRE PRESSURE MONITORING SYSTEM (TPMS))
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWD
Section 567 (Tire Pressure Monitoring System (TPMS))
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWDSECTION Section 567 (Tire Pressure Monitoring System (TPMS))
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Description And Operation
- Tire Pressure Monitoring System (TPMS) - Overview
- Tire Pressure Monitoring System (TPMS) - System Operation and Component Description
- Diagnosis And Testing
- Tire Pressure Monitoring System (TPMS)
- Diagnostic Trouble Code (DTC) Chart
- Global Customer Symptom Code (GCSC) Chart
- Symptom Chart: Tire Pressure Monitoring System
- Pinpoint Tests
- Pinpoint Test A: B1182:00
- Pinpoint Test B: B124D:02
- Pinpoint Test C: B1251:00
- Pinpoint Test D: Unable To Train TPMS Sensors
- Pinpoint Test E: TPMS (Tire Pressure Monitoring System) Warning Indicator Is On Continuously And The Message Center Displays Low Tire Pressure
- Pinpoint Test F: The BCM (Body Control Module) Will Not Enter TPMS (Tire Pressure Monitoring System) Sensor Training Mode
- Pinpoint Test G: One Or More TPMS (Tire Pressure Monitoring System) Sensors Do Not Train And No Diagnostic Trouble Codes (DTCS) Are Present
- Pinpoint Test H: U0146:00
- Pinpoint Test I: U1A00:00
- Pinpoint Test J: U0401:00, U0401:82
- Pinpoint Test K: U0559:56, U2100:00, U3000:04
- Pinpoint Test L: B1182:55, B1254:51, B1255:51, C1A56:51 Or C1A58:51
- Tire Pressure Monitoring System (TPMS)
- General Procedures
- Removal And Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.