Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021TRANSIT-350 HD BASE, VAN CARGO EXTENDED, 3.5L ENG VIN 8, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 472 (ABS GUIDED ROUTINE)PINPOINT TESTSPINPOINT TESTS AQ: CRUISE CONTROL BRAKING FAULTPOSSIBLE CAUSES
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWD
Possible Causes
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWDSECTION Possible Causes
WARNING: This page is about a different car, the 2019 Ford F-550 Super Duty, 2019 Ford F-450 Super Duty, 2019 Ford F-350 Super Duty, and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
- Vehicle damage
- CCM concern
- AQ1: RECHECK THE ABS MODULE DTCS
- Ignition ON, engine OFF.
Carry out the ABS self-test.
- Is DTC U2107:68 the only ABS module DTC present?
Yes No Go to AQ3. DIAGNOSE all other ABS module DTCs first. REFER to the ABS Module DTC Chart. - Ignition ON, engine OFF.
- AQ2: CHECK FOR IPMA DTCS
Carry out the IPMA self-test.
- Are any IPMA DTCs present?
Yes No DIAGNOSE the IPMA DTC. REFER to the Rear View Mirrors article. Go to AQ3. - AQ3: CHECK FOR CCM DTCS
Carry out the C-CM self-test.
- Are any CCM DTCs present?
Yes No DIAGNOSE the CCM DTC. REFER to the appropriate Cruise Control article. INSPECT the vehicle braking system for a dragging condition or another condition causing rapid vehicle deceleration.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.