SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021TRANSIT-350 HD BASE, VAN CARGO EXTENDED, 3.5L ENG VIN 8, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 472 (ABS GUIDED ROUTINE)DTC/SYMPTOM SELECTIONSYMPTOM CHART - ANTI-LOCK BRAKE SYSTEM (ABS) AND STABILITY CONTROLTHE HILL START ASSIST FEATURE IS INOPERATIVE, CANNOT BE DISABLED OR ENABLED
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWD

The hill start assist feature is inoperative, cannot be disabled or enabled

2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWDSECTION The hill start assist feature is inoperative, cannot be disabled or enabled
WARNING: This page is about a different car, the 2019 Ford F-550 Super Duty, 2019 Ford F-450 Super Duty, 2019 Ford F-350 Super Duty, and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
Possible Source Action
  • Network concern
  • IPC concern
  • PCM concern
  • RCM concern
  • ABS module concern
  • CARRY OUT the IPC self-test. DIAGNOSE all IPC DTCs. REFER to the Instrumentaion, Message Center and Warning Chimes article.
  • If there are no DTCs in the IPC, CARRY OUT the PCM KOEO self-test. DIAGNOSE all PCM module DTCs. REFER to the appropriate Electronic Engine Controls article.
  • If there are no DTCs in the PCM, CARRY OUT the RCM self-test. DIAGNOSE all RCM DTCs. REFER to the Supplemental Retraint System article.
  • If there are no DTCs in the RCM, CARRY OUT the ABS module self-test. DIAGNOSE all ABS module DTCs.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.