Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021TRANSIT-350 HD BASE, VAN CARGO EXTENDED, 3.5L ENG VIN 8, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 245 (ENGINE COOLING - 6.2L V8)REMOVAL AND INSTALLATIONCOOLING MODULEREMOVAL
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWD
Cooling Module: Removal
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWDSECTION Removal
WARNING: This page is about a different car, the 2019 Ford F-350 Super Duty and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
- Drain the cooling system. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding .
- Evacuate the A/C system. Refer to: Air Conditioning (A/C) System Recovery, Evacuation and Charging .
- Remove the air cleaner outlet pipe. Refer to: Air Cleaner Outlet Pipe .
- Remove the headlamp assemblies. Refer to: Headlamp Assembly .
-
- All Vehicles. Disconnect the horn electrical connector.
- Vehicles Equipped With Hood Ajar Switch. Disconnect the electrical connector.
- Vehicles Not Equipped With Hood Ajar Switch. Detach the wiring harness retainer.
- Vehicles With Park Aid Camera. Detach the wiring harness retainers.
- Detach the pin-type retainer, release the clips and position the washer fluid hose aside.
- Remove the bolts, push-pins and the radiator grille bracket.
Torque: Stage 1: 62 lb.in (7 Nm) | Stage 2: 22 lb.ft (30 Nm)
-
- Mark the hood latch.
- Remove the bolts, detach the retainer and position the hood latch aside.
Torque: 26 lb.ft (35 Nm)
-
- Detach the cable from the mounting bracket.
- Disconnect the hood latch release cable end.
- Detach the pin type retainers from the front end bolster and position the wiring harness aside.
- Remove the push-pins and the LH air deflector.
- Remove the condenser inlet, outlet nuts and disconnect the fittings.
Torque: 133 lb.in (15 Nm)
- Remove the transmission cooler tube secondary latches and detach the clip.
-
NOTE: Failure to cap the openings for the transmission cooler tubes may result in siphoning of the transmission fluid. This may result in damage to the transmission, if the transmission fluid is not checked and filled after the repair is completed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.