Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021TRANSIT-350 HD BASE, VAN CARGO EXTENDED, 3.5L ENG VIN 8, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 12 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (DIESEL))DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONSDTC P062A - FUEL PUMP A CONTROL CIRCUIT RANGE/PERFORMANCE
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWD
DTC P062A - Fuel Pump A Control Circuit Range/Performance
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWDSECTION DTC P062A - Fuel Pump A Control Circuit Range/Performance
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Ford Transit-350 HD, 2018 Ford Transit-350, 2018 Ford Transit-250, 2018 Ford Transit-150, and 2018 Ford F-550 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
P062A - FUEL PUMP A CONTROL CIRCUIT RANGE/PERFORMANCE
| For F-650/F-750 | |||
| Description: | This DTC sets when the airbags deploy and the FPM circuit shows the fuel pump is energized, or if the FPC request and FPM feedback do not correlate. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | |||
| For All Others | |||
| Description: | This DTC sets when the fuel pump control module sends an irrational fuel pump monitor duty cycle. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Clear the PCM DTCs. Repeat the self-test. If the DTC is retrieved again, install a new fuel pump control module. Refer to the appropriate Engine Controls - Fuel Charging And Controls article. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| F-650/F-750 | GO to PINPOINT TEST MA . | ||
| All others | Refer to the Description, Possible Causes and Diagnostic Aids for the DTC. | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.