Pinpoint Tests DT: Exhaust Pressure (EP) Sensor: Introduction

2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWDSECTION Introduction

This pinpoint test is intended to diagnose the following:

  • harness circuits: EP, SIGRTN, VREF
  • EP sensor (9J460)
  • PCM (12A650)
Fig 1: Exhaust Pressure (EP) Sensor Connector
G11849390Courtesy of FORD MOTOR CO.
Pin Circuit
3 EP (Exhaust Pressure)
2 SIGRTN (Signal Return)
1 VREF (Reference Voltage)

Powertrain Control Module (PCM) ConnectorΒ 

For PCM connector views or reference values, refer to Reference Values.

Vehicle Connector Pin Circuit
Corsair 2.5L,
Escape/Kuga 2.5L
198 PIN E16 EP
F-150 306 PIN B53 EP
All other vehicles 198 PIN B94 EP
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.