Test Procedure

2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWDSECTION Test Procedure
  1. AA1 CHECK FOR DTCS 
    • Carry out the PCM self-test.
    • Check for any other module DTCs.

    Are any DTCs other than DTC P164C or P168E present? 

    Yes No
    Diagnose all other DTCs before entering this pinpoint test. Refer to Engine Controls - Powertrain DTC Charts & Descriptions (Except Diesel & Hybrid) and the appropriate Engine Controls article or Service Information article to continue diagnosis. GO to  AA2
  2. AA2 CHECK FOR CORRECT AUTO START STOP SYSTEM OPERATION 
    NOTE: Verify the conditions that disable the auto start stop system operation are not present while checking the auto start stop system for correct operation. Refer to Powertrain Control Software, Auto Start Stop.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.