Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021TRANSIT-350 HD BASE, VAN CARGO EXTENDED, 3.5L ENG VIN 8, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSPASSIVE ANTI-THEFT SYSTEM (PATS)DIAGNOSIS AND TESTINGPASSIVE ANTI-THEFT SYSTEM (PATS)PINPOINT TESTSPINPOINT TEST G: DTC (DIAGNOSTIC TROUBLE CODE) B10D5:13
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWD
Pinpoint Test G: DTC (Diagnostic Trouble Code) B10D5:13
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWDSECTION Pinpoint Test G: DTC (Diagnostic Trouble Code) B10D5:13
- Normal Operation and Fault Conditions
REFER to: Passive Anti-Theft System (PATS) - System Operation and Component Description .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition BCM B10D5:13 PATS Antenna: Circuit Open Sets when there is an internal antenna circuit open. Possible Sources
- PATS transceiver
- G1 CHECK BCM (BODY CONTROL MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, carry out the BCM self-test.
Are there any other DTC's Present?
Yes DIAGNOSE all other DTC's first. Refer to Diagnostic Trouble Code (DTC) Chart No INSTALL a new PATS transceiver. REFER to: Passive Anti-Theft System (PATS) Transceiver .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.