Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021TRANSIT-150 XLT, 3.5L ENG VIN 8, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEFRAMES, SUBFRAMES & CROSSMEMBERSUNI-BODY, SUBFRAME AND MOUNTING SYSTEMREMOVAL AND INSTALLATIONENGINE CROSSMEMBERREMOVAL
2021 Ford Transit-150 XLT, 3.5L Eng VIN 8, AWD
Engine Crossmember: Removal
2021 Ford Transit-150 XLT, 3.5L Eng VIN 8, AWDSECTION Removal
NOTE:
Removal steps in this procedure may contain installation details.
- Refer to: Jacking and Lifting - Overview .
- Use the General Equipment: Wooden Block
Use the General Equipment: Transmission Jack
- Torque
: 76 lb.ft (103 Nm)
- If equipped
- On both sides.
Torque
: 22 lb.ft (30 Nm)
- On both sides.
Torque
: 52 lb.ft (70 Nm)
-
NOTE: This step is only necessary when installing a new component.
Torque
: 22 lb.ft (30 Nm)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.