SYS.OK|MANUAL.DB● LIVE
2021 Ford Ranger XLT, 4D Pickup Crew Cab, RWD

Quick Lookups: Fluids

2021 Ford Ranger XLT, 4D Pickup Crew Cab, RWDSECTION Fluids
FLUID CAPACITIES
Fluid Type Application Standard Metric Fluid Spec Note S/H
Air Cond Compressor Oil 2.70 OZS. 0.07 L MOTORCRAFT R-1234yf Refrigerant PAG Oil / YN-35 S
Air Cond Refrigerant 1.50 LBS. 0.68 KG R-1234yf S
Automatic Transmission Fluid 12.50 QTS. 11.82 L MOTORCRAFT Automatic Transmission Fluid MERCON ULV Approximate dry fill capacity. Actual amount may vary during fluid changes. S
Brake Fluid N/A N/A MOTORCRAFT DOT 4 Low Viscosity (LV) High Performance Motor Vehicle Brake Fluid S
Differential Gear Oil Front 1.64 PTS. 0.77 L MOTORCRAFT SAE 80W-90 Premium Rear Axle Lubricant S
Differential Gear Oil Rear,Locking Axle 3.38 PTS. 1.59 L MOTORCRAFT SAE 80W-90 Premium Rear Axle Lubricant S
Differential Gear Oil Rear,Standard Axle 3.76 PTS. 1.77 L MOTORCRAFT SAE 80W-90 Premium Rear Axle Lubricant S
Engine Coolant 11.62 QTS. 10.99 L MOTORCRAFT Yellow Antifreeze/Coolant Prediluted S
Engine Oil w/Filter 6.20 QTS. 5.86 L MOTORCRAFT SAE 5W-30 Premium Synthetic Blend Motor Oil Approximate capacity. SAE 0W-30 oil may be used in cold temperature operations: In an area of extreme cold, where the temperature falls below -29Deg.C (-20Deg.F). S
Fuel Tank 18.80 GALS. 71.16 L S
Transfer Case Fluid Power Transfer Unit 1.20 QTS. 1.13 L MOTORCRAFT Automatic Transmission Fluid MERCON LV S
Windshield Washer Fluid N/A N/A MOTORCRAFT Premium Windshield Wash Concentrate with Bitterant Follow the Manufacturer's Instructions for the mixture ratio. S
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.