Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021MUSTANG ECOBOOST PREMIUM, 2D CONVERTIBLE, 2.3L ENG VIN D, AUTOMATIC TRANSREPAIR AND DIAGNOSISGENERAL INFORMATIONDTC INDEXDTC INDEX (ACCELERATION CONTROL - ELECTRONIC ENGINE CONTROL)ACCELERATION CONTROL SYSTEM DTCS
2021 Ford Mustang EcoBoost Premium, 2D Convertible, 2.3L Eng VIN D, Automatic Trans
Acceleration Control System DTCS
2021 Ford Mustang EcoBoost Premium, 2D Convertible, 2.3L Eng VIN D, Automatic TransSECTION Acceleration Control System DTCS
| DTC | Description | Action |
|---|---|---|
| P060D:00 | Internal Control Module Accelerator Pedal Position Performance: No Sub Type Information | GO to Pinpoint Test DK |
| P1575:00 | Pedal Position Out Of Self Test Range: No Sub Type Information | GO to Pinpoint Test DK |
| P2122:00 | Throttle/Pedal Position Sensor/Switch D Circuit Low: No Sub Type Information | GO to Pinpoint Test DK |
| P2123:00 | Throttle/Pedal Position Sensor/Switch D Circuit High: No Sub Type Information | GO to Pinpoint Test DK |
| P2127:00 | Throttle/Pedal Position Sensor/Switch E Circuit Low: No Sub Type Information | GO to Pinpoint Test DK |
| P2128:00 | Throttle/Pedal Position Sensor/Switch E Circuit High: No Sub Type Information | GO to Pinpoint Test DK |
| P2138:00 | Throttle/Pedal Position Sensor/Switch D/E Voltage Correlation: No Sub Type Information | GO to Pinpoint Test DK |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.