Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Resetting Long Term Fuel Trims
Long term fuel trim corrections are reset by resetting the keep alive memory (KAM). Refer to Resetting The Keep Alive Memory (KAM). After making a fuel system repair, reset the KAM. For example, if dirty or plugged injectors cause the engine to run lean and generate rich long term corrections, installing new injectors and not resetting the KAM causes the engine to run very rich. The rich correction eventually leans out during closed loop operation, but the vehicle may have poor driveability and high carbon monoxide (CO) emissions while it is learning.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.