SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EXPEDITION PLATINUM, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 987 (MULTIFUNCTION ELECTRONIC MODULES)REMOVAL AND INSTALLATIONRADIO TRANSCEIVER MODULE (RTM)INSTALLATION
2021 Ford Expedition Platinum, RWD

Radio Transceiver Module (RTM): Installation

2021 Ford Expedition Platinum, RWDSECTION Installation
WARNING: This page is about a different car, the 2021 Lincoln Nautilus. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: Obtain the specified adhesive commercially. Depending on the headliner and optional wire harness(es), the purchase of multiple tubes is suggested.

    1. Position the RTM onto the new headliner, making sure the harness has enough length to connect to the RTM.
    2. Apply the adhesive in the same location as the factory installed adhesive on the RTM to avoid any NVH concern(s).

      Material: 3M™ Super-Fast Repair Adhesive / 04747

  2. To install, reverse the removal procedure.
  3. Using the previous diagnostic scan tool session, carry out the PMI procedure for the RTM.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.