All-Wheel Drive (AWD) Module: Installation

2021 Ford Expedition Platinum, RWDSECTION Installation
WARNING: This page is about a different car, the 2019 Lincoln Nautilus. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse the removal procedure.
    NOTE: Carry out the remaining steps only if installing a new AWD module.
  2. NOTE: The 16/17 -digit alpha numeric bar code is located on the label attached to the Rear Drive Unit (RDU).

    Using the scan tool, configure RDU bar code to AWD module through the OBD port.

  3. Using a diagnostic scan tool, complete the PMI process for the AWD module following the on-screen instructions.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.