Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
TBM Wake Up
The following conditions describe the normal operation of the TBM at start up.
When the ignition is set to the ON position and the manual lever is set all the way to the left with a gain of 10, the message center should display TRAILER DISCONNECTED. At the same time, with the vehicle stationary, battery voltage should be present at pin 3 of trailer tow connector C4099 .
When not braking the TBM sends a voltage pulse every 4 seconds to pin 3 of the trailer tow connector to determine if a trailer is connected to the trailer tow connector.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.