Diagnostic Trouble Code (DTC) Chart

2021 Ford Edge SE, 4WDSECTION Diagnostic Trouble Code (DTC) Chart
WARNING: This page is about a different variant/trim than selected.

Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .

Diagnostic Trouble Code Chart 

Module DTC Description Action
PCM P0116:00 Engine Coolant Temperature Sensor 1 Circuit Range/Performance: No Sub Type Information GO to Pinpoint Test DL 
PCM P0116:00 Engine Coolant Temperature Sensor 1 Circuit Range/Performance: No Sub Type Information GO to Pinpoint Test DX 
PCM P0117:00 Engine Coolant Temperature Sensor 1 Circuit Low: No Sub Type Information GO to Pinpoint Test DX 
PCM P0118:00 Engine Coolant Temperature Sensor 1 Circuit High: No Sub Type Information GO to Pinpoint Test DX 
PCM P0119:00 Engine Coolant Temperature Sensor 1 Circuit Intermittent/Erratic: No Sub Type Information GO to Pinpoint Test DX 
PCM P011E:00 Engine Coolant Temperature 1 / Ambient Air Temperature Correlation: No Sub Type Information GO to Pinpoint Test DX 
PCM P0125:00 Insufficient Coolant Temp For Closed Loop Fuel Control: No Sub Type Information GO to Pinpoint Test DL 
PCM P0125:00 Insufficient Coolant Temp For Closed Loop Fuel Control: No Sub Type Information GO to Pinpoint Test DX 
PCM P0128:00 Coolant Thermostat (Coolant Temp Below Thermostat Regulating Temperature): No Sub Type Information GO to Pinpoint Test DL 
PCM P0128:00 Coolant Thermostat (Coolant Temp Below Thermostat Regulating Temperature): No Sub Type Information GO to Pinpoint Test DX 
PCM P017C:00 Cylinder Head Temperature Sensor Circuit Low: No Sub Type Information GO to Pinpoint Test DL 
PCM P017D:00 Cylinder Head Temperature Sensor Circuit High: No Sub Type Information GO to Pinpoint Test DL 
PCM P101F:00 Cylinder Head Temperature Sensor 1 Out Of Self Test Range: No Sub Type Information GO to Pinpoint Test DL 
PCM P1116:00 Engine Coolant Temperature Sensor Out Of Self Test Range: No Sub Type Information GO to Pinpoint Test DX 
PCM P1117:00 Engine Coolant Temperature Sensor Circuit Intermittent: No Sub Type Information GO to Pinpoint Test DX 
PCM P111B:00 Engine Coolant Warm-Up Not Detected: No Sub Type Information GO to Pinpoint Test DX 
PCM P1285:00 Cylinder Head Over Temperature Condition: No Sub Type Information GO to Pinpoint Test DL 
PCM P1299:00 Cylinder Head Over Temperature Protection Active: No Sub Type Information GO to Pinpoint Test DL 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.