SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 5 (ENGINE - 2.7L ECOBOOST (238KW/324PS) SPECIFICATIONS, DESCRIPTION AND OPERATION, DIAGNOSIS AND TESTING, GENERAL PROCEDURES, REMOVAL AND INSTALLATION(PT1))REMOVAL AND INSTALLATIONENGINE MOUNTINSTALLATION
2021 Ford Edge SE, 4WD

Engine Mount: Installation

2021 Ford Edge SE, 4WDSECTION Installation
WARNING: This page is about a different variant/trim than selected.
  1. Install the engine mount and bracket assembly.

    1. Install the new engine mount bracket-to-engine nuts finger tight.
    2. Install the new engine mount-to-frame nut finger tight.
    3. Install the new engine mount-to-frame bolts finger tight.
    4. Tighten the new engine mount bracket-to-engine nuts.

      Torque : 59 lb.ft (80 Nm)

    GFD594165Courtesy of FORD MOTOR COMPANY
  2. Remove the floor jack and wooden block. Use the General Equipment: Wooden Block Use the General Equipment: Trolley Jack
    GFD594303Courtesy of FORD MOTOR COMPANY
    1. Tighten the engine mount-to-frame nut.

      Torque : 66 lb.ft (90 Nm)

    2. Tighten the engine mount-to-frame bolts.

      Torque : 81 lb.ft (110 Nm)

    GFD594170Courtesy of FORD MOTOR COMPANY
  4. Position the coolant hose and attach the retainer.
    GFD594305Courtesy of FORD MOTOR COMPANY
  5. NOTE: When removing any turbocharger air intake system components, make sure to cover any open ports to prevent debris from entering the system. The turbocharger compressor vanes can be damaged by even the smallest particles. All components need to be inspected and cleaned prior to installation or reassembly.

    1. Uncover, clean and inspect all open ports.
    2. Install the CAC outlet pipe and tighten the clamps.

      Torque : 44 lb.in (5 Nm)

    GFD593998Courtesy of FORD MOTOR COMPANY
    1. Install the engine appearance cover and the nut.

      Torque : 42 lb.in (4.8 Nm)

    2. Install the bolt.

      Torque : 93 lb.in (10.5 Nm)

    GFD594304Courtesy of FORD MOTOR COMPANY
  7. Install the RH underbody shield and the retainers.
GFD594302Courtesy of FORD MOTOR COMPANY
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.