SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 99 (STEERING COLUMN)REMOVAL AND INSTALLATIONSTEERING COLUMNINSTALLATION
2021 Ford Edge SE, 4WD

Steering Column: Installation

2021 Ford Edge SE, 4WDSECTION Installation
WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: Transfer parts as needed.

    To install, reverse the removal procedure.

    Vehicles with power adjustable steering column 

  2. NOTE: This step is only necessary when installing a new component.

    If a new memory steering column has been installed, use the steering column control switch and set the soft stops as follows.

    1. Move the column upward until it reaches the end of travel.
    2. Move the column in the same direction until it reaches the end of travel again.
    3. Move the column downward until it reaches the end of travel.
    4. Move the column in the same direction until it reaches the end of travel again.

    GFD201111Courtesy of FORD MOTOR COMPANY
  3. NOTE: This step is only necessary when installing a new component.

    If a new memory steering column has been installed, use the steering column control switch and set the soft stops as follows.

    1. Move the column rearward until it reaches the end of travel.
    2. Move the column in the same direction until it reaches the end of travel again.
    3. Move the column forward until it reaches the end of travel.
    4. Move the column in the same direction until it reaches the end of travel again.

GFD201112Courtesy of FORD MOTOR COMPANY
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.