Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Test A : Engine Does Not Crank - Without Push-Button Start: Notes
Refer to Starting System for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Starting System - System Operation and Component Description .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| P06E9 | Engine Starter Performance | No engine rotation detected during crank event. |
Possible Sources
- Battery
- Battery cables
- Starter motor
- BJB starter relay
Visual Inspection and Diagnostic Pre-checks
- Inspect the Run/start relay.
- Inspect the high current BJB connections.
- Verify the BJB fuse 63 (30A).
- Verify the BCM fuse 18 (5A).
- Inspect the Integrated Keyhead Transmitter (IKT).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.