Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel Pump Driver Module (FPDM): Removal
2021 Ford Edge SE, 4WDSECTION Removal
WARNING: This page is about a different car, the 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
All vehicles
- With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview
.
Pickup
NOTE: The fuel pump driver module (FPDM) is attached to the top of the frame rear crossmember. - Disconnect the fuel pump driver module (FPDM) electrical connector.
- Remove the fuel pump driver module (FPDM) retainers and then remove the fuel pump driver module (FPDM).
Chassis Cab
NOTE: The fuel pump driver module (FPDM) is attached to the front of the frame rear crossmember. - Disconnect the fuel pump driver module (FPDM) electrical connector.
- Remove the fuel pump driver module (FPDM) retainers and then remove the fuel pump driver module (FPDM).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.