Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Cruise Control Module (CCM): Removal
2021 Ford Edge SE, 4WDSECTION Removal
WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
Cruise control module (CCM)
-
NOTE: If installing a new CCM, it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new CCM after installation.
Using a diagnostic scan tool, begin the PMI process for the CCM following the onscreen instructions.
- Remove the bolts and the CCM cover.
- Remove the CCM nuts.
- Remove the CCM.
- Release the CCM grommets from the ball studs.
- Disconnect the CCM electrical connector.
Cruise control module (CCM) bracket
- Remove the front bumper. Refer to: Front Bumper .
- Separate the wiring harness guides and position the harness aside.
- Remove the screws and the CCM bracket.
Torque: 42 lb.in (4.8 Nm)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.