Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 76 (CRUISE CONTROL SYSTEM - VEHICLES WITH: ADAPTIVE CRUISE CONTROL)DIAGNOSIS AND TESTINGCRUISE CONTROLPINPOINT TESTSPINPOINT TEST G : THE ADAPTIVE CRUISE CONTROL DOES NOT FUNCTION IN RAIN OR SNOW CONDITIONSNOTES
2021 Ford Edge SE, 4WD
Pinpoint Test G : The Adaptive Cruise Control Does Not Function In Rain Or Snow Conditions: Notes
2021 Ford Edge SE, 4WDSECTION Notes
WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
Refer to Cruise Control for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Cruise Control - System Operation and Component Description .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| C1A67:97 | Forward Looking Sensor: Component Or System Operation Obstructed Or Blocked | Set by the CCM as a continuous memory and on-demand DTC if the CCM detects an obstruction or if the sensor is blocked. This DTC may also set when the CCM does not see a vehicle or object on the road for an extended period. |
NOTE:
If a snow plow or similar equipment is installed on the front end of the vehicle, this may obstruct the CCM radar sensor, causing the adaptive cruise control to operate erratically. The adaptive cruise control should be disabled using the menu options when a snow plow or similar equipment is installed.
Possible Sources
- Front bumper
- Blockage or obstruction
- CCM mounting bracket
- CCM alignment
- CCM
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.