SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 741 (ENGINE CONTROLS - POWERTRAIN (DIESEL) - DTC P1261 - P2185)DTC P208A (PCM) - REDUCTANT PUMP CONTROL CIRCUIT OPEN LOAD
2021 Ford Edge SE, 4WD

DTC P208A (PCM) - Reductant Pump Control Circuit Open Load

2021 Ford Edge SE, 4WDSECTION DTC P208A (PCM) - Reductant Pump Control Circuit Open Load
WARNING: This page is about a different car, the 2020 Ford F-550 Super Duty, 2020 Ford F-450 Super Duty, 2020 Ford F-350 Super Duty, 2020 Ford F-250 Super Duty, and 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
DTC DESCRIPTION P208A (PCM) - REDUCTANT PUMP CONTROL CIRCUIT OPEN LOAD

Description:  This DTC sets when the reductant pump assembly voltage is greater than or less than a calibrated limit for a calibrated amount of time.
Possible Causes: 
  • RDPC circuit open
  • RDPC circuit short to ground
  • RDPC circuit short to voltage
  • VPWR circuit open
  • VPWR circuit short to ground
  • VPWR circuit short to voltage
  • Reductant pump assembly open
  • Reductant pump assembly short to ground
  • Reductant pump assembly short to voltage
Diagnostic Aids:  The presence of this DTC may indicate that the vehicle is operating in derate mode and may experience a loss of power. After repair, the vehicle may still display a system warning message. Drive the vehicle until the system warning message has cleared from the instrument cluster message center.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to PINPOINT TEST RG .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.