Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC P062A - Fuel Pump A Control Circuit Range/Performance
2021 Ford Edge SE, 4WDSECTION DTC P062A - Fuel Pump A Control Circuit Range/Performance
WARNING: This page is about a different car, the 2020 Ford F-550 Super Duty, 2020 Ford F-450 Super Duty, 2020 Ford F-350 Super Duty, 2020 Ford F-250 Super Duty, and 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
DTC DESCRIPTION P062A - FUEL PUMP A CONTROL CIRCUIT RANGE/PERFORMANCE
| For F-650/F-750 | |||
| Description: | This DTC sets when the airbags deploy and the FPM circuit shows the fuel pump is energized, or if the FPC request and FPM feedback do not correlate. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | |||
| For All Others | |||
| Description: | This DTC sets when the fuel pump control module sends an irrational fuel pump monitor duty cycle. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Clear the PCM DTCs. Repeat the self-test. If the DTC is retrieved again, install a new fuel pump control module. Refer to the Fuel Charging and Controls article. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| F-650/F-750 | GO to PINPOINT TEST MA . | ||
| All others | Refer to the Description, Possible Causes and Diagnostic Aids for the DTC. | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.