DTC P0601 - Internal Control Module Memory Checksum Error

2021 Ford Edge SE, 4WDSECTION DTC P0601 - Internal Control Module Memory Checksum Error
WARNING: This page is about a different car, the 2020 Ford F-550 Super Duty, 2020 Ford F-450 Super Duty, 2020 Ford F-350 Super Duty, 2020 Ford F-250 Super Duty, and 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
DTC DESCRIPTION P0601 - INTERNAL CONTROL MODULE MEMORY CHECKSUM ERROR

Description:  This DTC sets when the PCM central processor unit (CPU) internal checks return an incorrect value.
Possible Causes: 
  • An attempt was made to change the calibration
  • Aftermarket performance products
  • Incorrect PCM calibration
  • Damaged PCM
Diagnostic Aids:  Reprogram or update the calibration. Reprogram the vehicle identification VID block. Check for other DTCs or drive symptoms for further action. Make sure to check for aftermarket performance products before installing a new PCM. If it is necessary to install a new PCM, refer to FLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) . Programming the VID Block for a Replacement PCM.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to PINPOINT TEST Y .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.