SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 739 (ENGINE CONTROLS - POWERTRAIN (DIESEL) - DTC P0001 - P02FA)DTC P0219 - ENGINE OVER SPEED CONDITION
2021 Ford Edge SE, 4WD

DTC P0219 - Engine Over Speed Condition

2021 Ford Edge SE, 4WDSECTION DTC P0219 - Engine Over Speed Condition
WARNING: This page is about a different car, the 2020 Ford F-550 Super Duty, 2020 Ford F-450 Super Duty, 2020 Ford F-350 Super Duty, 2020 Ford F-250 Super Duty, and 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
DTC DESCRIPTION P0219 - ENGINE OVER SPEED CONDITION

Description:  This DTC sets when the vehicle has been operated in a manner which caused the engine speed to exceed a calibrated limit. The engine RPM is continuously monitored and evaluated by the PCM.
For additional information on the engine RPM limiter, refer to POWERTRAIN CONTROL SOFTWARE .
Possible Causes: 
  • Wheel slippage (water, ice, mud, and snow)
  • Excessive engine RPM in NEUTRAL or operated in the incorrect transmission gear
Diagnostic Aids:  This DTC may be accompanied by other DTCs. If any other DTCs are present, disregard DTC P0219 at this time. Diagnose any other DTCs first.
If there are no other symptoms, return the vehicle to the customer with information about the DTC.
If a symptom is present, refer to NO DIAGNOSTIC TROUBLE CODES (DTCS) PRESENT SYMPTOM CHART INDEX .
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All Refer to the Description, Possible Causes and Diagnostic Aids for the DTC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.