SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 737 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID) - DTC P2096 - PXXXX, DTC U0046 - UXXXX)DTC U1012 - INVALID INTERNAL CONTROL MODULE MONITORING DATA RECEIVED FROM ANTI-LOCK BRAKE SYSTEM (ABS) CONTROL MODULE
2021 Ford Edge SE, 4WD

DTC U1012 - Invalid Internal Control Module Monitoring Data Received From Anti-Lock Brake System (ABS) Control Module

2021 Ford Edge SE, 4WDSECTION DTC U1012 - Invalid Internal Control Module Monitoring Data Received From Anti-Lock Brake System (ABS) Control Module
WARNING: This page does not describe the selected car, but rather 24 other vehicles, including the 2019 Lincoln Navigator, 2019 Lincoln Nautilus, 2019 Lincoln MKZ, 2019 Lincoln MKT, and 2019 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.
DTC DESCRIPTION U1012 - INVALID INTERNAL CONTROL MODULE MONITORING DATA RECEIVED FROM ANTI-LOCK BRAKE SYSTEM (ABS) CONTROL MODULE

Description:  Network DTC concerns occur during module to module communication.
Possible Causes: 
  • Invalid data network concerns - data is transferred within the normal inter-module message, but contains known invalid data. The receiving module logs a DTC related to the invalid data concern.
Diagnostic Aids: 
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to PINPOINT TEST QA .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.