Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 736 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID) - DTC P0607 - P2091)DTC P061B - INTERNAL CONTROL MODULE TORQUE CALCULATION PERFORMANCE
2021 Ford Edge SE, 4WD
DTC P061B - Internal Control Module Torque Calculation Performance
2021 Ford Edge SE, 4WDSECTION DTC P061B - Internal Control Module Torque Calculation Performance
WARNING: This page does not describe the selected car, but rather 24 other vehicles, including the 2019 Lincoln Navigator, 2019 Lincoln Nautilus, 2019 Lincoln MKZ, 2019 Lincoln MKT, and 2019 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.
DTC DESCRIPTION P061B - INTERNAL CONTROL MODULE TORQUE CALCULATION PERFORMANCE
| Description: This DTC sets when a calculation error occurs in the PCM. | |||
Possible Causes:
|
|||
| Diagnostic Aids:
Check for sensor and circuit related DTCs. Do not install a new electronic throttle body (ETB) for this DTC. The presence of this DTC may indicate that the vehicle is operating in failure mode and may experience a loss of power. |
|||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST QE . | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.