SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 72 (WIPERS SYSTEM AND WASHERS SYSTEM)DIAGNOSIS AND TESTINGWIPERS AND WASHERSPINPOINT TESTSPINPOINT TEST A : ALL WINDSHIELD WIPER MODES ARE INOPERATIVENOTES
2021 Ford Edge SE, 4WD

Pinpoint Test A : All Windshield Wiper Modes Are Inoperative: Notes

2021 Ford Edge SE, 4WDSECTION Notes
WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

Refer to Wipers and Washers for schematic and connector information.

Normal Operation and Fault Conditions 

REFER to: Wipers and Washers - System Operation and Component Description .

BCM DTC Fault Trigger Conditions 

DTC Description Fault Trigger Conditions
B130F:12 Run Accessory Control: Circuit Short To Battery Sets when the BCM detects a short to voltage from the wiper relay control circuit.
B130F:14 Run Accessory Control: Circuit Short To Ground or Open Sets when the BCM detects an open from the wiper relay control circuit.

SCCM DTC Fault Trigger Conditions 

DTC Description Fault Trigger Conditions
B1131:02 Wiper motor module: General Signal Failure Sets when the input to the windshield wiper motor from the fail-safe circuit does not match the requested input from the SCCM.

Possible Causes 

  • Fuse
  • Wiring, terminals or connectors
  • Wiper/washer switch
  • BJB relay module
  • Windshield wiper motor
  • SCCM
  • BCM

Visual Inspection and Diagnostic Pre-checks 

  • Inspect the BJB fuse 77 (30A) and make sure it is OK.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.