Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 704 (CLIMATE CONTROL SYSTEM - GENERAL INFORMATION (SPECIFICATIONS - DESCRIPTION & OPERATION))DESCRIPTION AND OPERATIONCLIMATE CONTROL SYSTEM - VEHICLES WITH: ELECTRONIC MANUAL TEMPERATURE CONTROL (EMTC) - COMPONENT LOCATIONNOTES
2021 Ford Edge SE, 4WD
Climate Control System - Vehicles With: Electronic Manual Temperature Control (EMTC) - Component Location: Notes
2021 Ford Edge SE, 4WDSECTION Notes
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Description |
|---|---|
| 1 | Driver Side Register |
| 2 | In-Vehicle Temperature and Humidity Sensor |
| 3 | Sunload Sensor |
| 4 | Passenger Side Register |
| 5 | Center Registers |
| 6 | HVAC Module |
| Item | Description |
|---|---|
| 1 | Air Distribution Door Actuator |
| 2 | Driver Side Register Air Discharge Temperature Sensor |
| 3 | Air Inlet Door Actuator |
| 4 | Cabin Air Filter |
| 5 | Blower Motor Control Module |
| 6 | Evaporator |
| 7 | Evaporator Temperature Sensor |
| 8 | Driver Temperature Door Actuator |
| 9 | Heater Core |
| 10 | Driver Side Footwell Air Discharge Temperature Sensor |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.