Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Rocker Arm LH: Installation
All rocker arms
-
-
NOTE: Lubricate the rocker arm and shaft with clean engine oil.
Slide the rocker arms on the shaft.
- Install the rocker arm shaft plates.
-
NOTE: The sleeves are captured on the bolts.
Using a hammer, tap the bolts to seat the sleeve in the rocker arm shaft.
-
- Lubricate the rocker arm shaft-to-valve tip and rocker arm-to-camshaft lobe contact area with clean engine oil prior to installation.
Material: Motorcraft ® SAE 5W-30 Synthetic Blend Motor Oil / XO-5W30-QSP (WSS-M2C946-A)
- Lubricate the all LH camshaft lopes with clean engine oil.
Material: Motorcraft ® SAE 5W-30 Synthetic Blend Motor Oil / XO-5W30-QSP (WSS-M2C946-A)
Exhaust rocker arms
-
NOTE: Only rotate the engine in a clockwise direction.
If needed, rotate the engine clockwise until the No. 6 cylinder camshaft exhaust lobe is positioned so the exhaust valve would be fully closed.
- Install the LH exhaust rocker arm shaft assembly and the bolts finger-tight and tighten the bolts sequence shown, in 3 stages.
Torque:
Stage 1: 89 lb.in (10 Nm)
Stage 2: 177 lb.in (20 Nm)
Stage 3: 60 °
Intake rocker arms
-
NOTE: Only rotate the engine in a clockwise direction.
If needed, rotate the engine clockwise until the No. 6 cylinder camshaft intake lobe is positioned at the bottom of its rotation so the intake valve would be fully closed.
- Install the LH intake rocker arm shaft assembly and the bolts finger-tight and tighten the bolts sequence shown, in 3 stages.
Torque:
Stage 1: 89 lb.in (10 Nm)
Stage 2: 177 lb.in (20 Nm)
Stage 3: 60 °
All rocker arms
- Install the LH valve cover. Refer to: Valve Cover LH .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.