Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 685 (PASSIVE ANTI-THEFT SYSTEM (PATS) - VEHICLES WITH: PUSH BUTTON START)DIAGNOSIS AND TESTINGPASSIVE ANTI-THEFT SYSTEM (PATS)PINPOINT TESTSPINPOINT TEST F: DTC (DIAGNOSTIC TROUBLE CODE) B10DA:51
2021 Ford Edge SE, 4WD
Pinpoint Test F: DTC (Diagnostic Trouble Code) B10DA:51
2021 Ford Edge SE, 4WDSECTION Pinpoint Test F: DTC (Diagnostic Trouble Code) B10DA:51
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Normal Operation and Fault Conditions
REFER to: Passive Anti-Theft System (PATS) - System Operation and Component Description .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition BCM B10DA:51 PATS Target Identifier: Not Programmed Sets when there is no PCM/ SOBDMC (if equipped) ID stored in the BCM memory. Possible Sources
- There is no PCM and the SOBDMC (if equipped) ID stored in the BCM memory
- F1 CHECK BCM (BODY CONTROL MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, carry out the BCM self-test.
Are there any other Diagnostic Trouble Codes (DTCs) Present?
Yes DIAGNOSE all other Diagnostic Trouble codes (DTCs) first. Refer to DTC Chart(s) No CARRY OUT a parameter reset. REFER to: Anti-Theft Key Programming - Scan Tool .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.