Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 665 (ENGINE - 5.0L 32V TI-VCT)REMOVAL AND INSTALLATIONENGINE MOUNT RHINSTALLATION
2021 Ford Edge SE, 4WD
Engine Mount RH: Installation
2021 Ford Edge SE, 4WDSECTION Installation
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
-
NOTE: If a new RH engine mount is installed, remove the 2 studs prior to positioning the assembly in the vehicle.
Install the RH engine mount and the new bolts.
Torque: 55 lb.ft (75 Nm)
-
- Using the adjustable stand, lower the engine to the installed position. Use the General Equipment: Vehicle/Axle StandsUse the General Equipment: Wooden Block
- Remove the stand and wood block.
- Position the stabilizer bar and install the new nuts.
Torque: 41 lb.ft (55 Nm)
-
NOTE: Only use hand tools when installing the engine mount studs or damage to the engine mount can occur.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.