Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Test F: DTC P162F
2021 Ford Edge SE, 4WDSECTION Pinpoint Test F: DTC P162F
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Refer to ELECTRONIC ENGINE CONTROLS - 3.5L
for schematic and connector information.
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition PCM P162F:00 Starter Motor Disabled - Engine Crank Time Too Long: No Sub Type Information This DTC sets when the PCM detects Engine Crank Time Too Long. Possible Sources
- PCM
- Wiring, terminals or connectors
- F1 RETRIEVE DIAGNOSTIC TROUBLE CODES (DTCS)
- Ignition ON.
- Using a diagnostic scan tool, perform PCM self-tests.
Is DTC P162F recorded?
Yes This DTC sets in the PCM when the engine has been cranked for more than a total of 60 seconds without allowing sufficient time for the starter to cool. Diagnose all other DTCs and symptoms. Check the charging system voltage and correct as necessary. Clear the DTC No The repair is completed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.