Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Test E: DTC P06E4
2021 Ford Edge SE, 4WDSECTION Pinpoint Test E: DTC P06E4
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Refer to ELECTRONIC ENGINE CONTROLS - 3.5L
for schematic and connector information.
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition PCM P06E4:00 Control Module Wake-up Circuit Performance: No Sub Type Information This DTC sets when the PCM detects control module Wake-up circuit performance. Possible Sources
- PCM
- Wiring, terminals or connectors
- E1 RETRIEVE DIAGNOSTIC TROUBLE CODES (DTCS)
- Ignition ON.
- Using a diagnostic scan tool, perform PCM self-tests.
Is DTC P06E4 recorded?
Yes RETRIEVE and RECORD all CMDTCs. If BCMDTC C113A:11 or C113A:15 is found, GO to Pinpoint Test D Clear all Diagnostic Trouble Codes (DTCs). RERUN the PCM self-test. If the DTC returns, CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If no Technical Service Bulletins (TSBs) address this concern, refer to PCM GUIDED ROUTINE TESTING
Internet Explorer version 11 or greater is required to perform this Pinpoint Test.No The repair is completed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.