SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 648 (FUEL SYSTEM - GENERAL INFORMATION - 3.5L ECOBOOST (BM))GENERAL PROCEDURESFUEL SYSTEM PRESSURE CHECK
2021 Ford Edge SE, 4WD

Fuel System Pressure Check

2021 Ford Edge SE, 4WDSECTION Fuel System Pressure Check
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

For information on Ford Color Coded Illustrations refer to OEM COLOR CODING .

Special Tool(s) / General Equipment 

GFD560086Courtesy of FORD MOTOR COMPANY
 310-D009 (D95L-7211-A) Fuel Pressure Test Kit

Check 

NOTE: This Fuel System Pressure Check is for the low pressure side of the system.
  1. Release the fuel system pressure. Refer to: Fuel System Pressure Release .
  2. Disconnect the battery ground cable. Refer to: Battery Cables - 3.5L EcoBoost (BM) .
  3. Remove the engine appearance cover retainers, release the engine appearance cover from the rear retainers and then remove the engine appearance cover.

    Torque

    : 97 lb.in (11 Nm)

    GFD560097Courtesy of FORD MOTOR COMPANY
  4. If equipped. Remove the high pressure fuel pump noise insulator.
    GFD560098Courtesy of FORD MOTOR COMPANY
  5. Disconnect the fuel jumper tube-to-high pressure pump quick release coupling. Refer to: Quick Release Coupling .
  6. Install the Fuel Pressure Test Kit between the fuel jumper tube and the High Pressure Fuel Pump.

    Use Special Service Tool: 310-D009 (D95L-7211-A) Fuel Pressure Test Kit.

    GFD560099Courtesy of FORD MOTOR COMPANY
  7. NOTE: The Fuel Pump (FP) control module electrical connector was previously disconnected to release the fuel system pressure and must be reconnected to test the fuel system pressure.

    Reconnect the Fuel Pump (FP) control module electrical connector.

  8. Reconnect the battery ground cable. Refer to: Battery Cables - 3.5L EcoBoost (BM) .
  9. NOTE: Carry out a Key ON Engine OFF (KOEO) visual inspection for fuel leaks prior to completing the fuel system pressure test.

    Test the fuel system pressure to make sure it is within the specified range. For additional information, refer to SPECIFICATIONS .

  10. After completion of the fuel system pressure test, disconnect the battery ground cable, open the drain valve on the Fuel Pressure Test Kit and release any residual fluid into an appropriate container. Refer to: Battery Cables - 3.5L EcoBoost (BM) .
  11. Remove the Fuel Pressure Test Kit by reversing the installation steps.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.