Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Test L: Auto-Start-Stop System Cannot Be Disabled By Driver
2021 Ford Edge SE, 4WDSECTION Pinpoint Test L: Auto-Start-Stop System Cannot Be Disabled By Driver
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Normal Operation and Fault Conditions
- Refer to AUTO-START-STOP SYSTEM for schematic and connector information.
- REFER to BCM DTC Chart in DTC Chart(s) .
- Refer to the appropriate Information and Entertainment System article for the procedure.
Possible Sources
- Wiring, terminals or connectors
- Auto-start-stop disable switch
- FCIM
Diagnostic steps are not provided for this symptom or DTC. REFER to: Diagnostic Methods
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.