SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 637 (FULL FRAME AND BODY MOUNTING)REMOVAL AND INSTALLATIONFRAME MEMBERS-REAR FRAME SECTIONREMOVAL
2021 Ford Edge SE, 4WD

Frame Members-Rear Frame Section: Removal

2021 Ford Edge SE, 4WDSECTION Removal
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Restore the vehicle to manufacturer's dimensions. Refer to: BODY AND FRAME .
  2. Remove the following items:

    1. Refer to: Rear Bumper .
    2. Refer to: Pickup Bed .
    3. As equipped. Refer to: Muffler and Tailpipe . Refer to: Muffler and Tailpipe . Refer to: Muffler and Tailpipe . Refer to: Muffler and Tailpipe . Refer to: Muffler . Refer to: Tailpipe . Refer to: Rear Muffler .
    4. As equipped. Refer to: Fuel Tank Filler Pipe . Refer to: Fuel Tank Filler Pipe . Refer to: Fuel Tank Filler Pipe . Refer to: Fuel Tank Filler Pipe . Refer to: Fuel Tank Filler Pipe . Refer to: Fuel Tank Filler Pipe .
    5. Refer to: Rear Shock Absorber .
    6. Refer to: Spring .

  3. Rear frame section overview.
    GFD563607Courtesy of FORD MOTOR COMPANY
  4. Position the vehicle on a frame rack and anchor per manufacturer's instructions.
  5. NOTE: The rear frame section is retained by a welded joint and upper and lower frame rail reinforcements approximately midway between the leaf spring frame brackets.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.