Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 637 (FULL FRAME AND BODY MOUNTING)REMOVAL AND INSTALLATIONBODYINSTALLATION
2021 Ford Edge SE, 4WD
Removal And Installation: Body: Installation
2021 Ford Edge SE, 4WDSECTION Installation
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
-
NOTE: Prior to lowering the body onto the chassis, verify that the steering shaft, hoses and wire harnesses are clear of obstruction and have been positioned aside to prevent damage.
To install, reverse the removal procedure.
- Align the tires to the marks on the floor.
- With aide of an assistant in aligning the body-to-chassis, lower the body on the chassis.
- Install new body mount bolts for all discarded.
- Reverse removal procedure steps to complete installation.
- Carry out the brake bleeding procedure. Refer to: Brake System Pressure Bleeding .
- Check and fill the transmission fluid. Refer to: Transmission Fluid Level Check .
- Refill the cooling system. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding . Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding . Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding . Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding . Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding .
- Charge the A/C refrigerant. Refer to: Air Conditioning (A/C) System Recovery, Evacuation and Charging - Vehicles With: R1234YF Refrigerant . Refer to: Air Conditioning (A/C) System Recovery, Evacuation and Charging - Vehicles With: R134A Refrigerant .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.