Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 635 (ENGINE - 3.3L DURATEC-V6)ASSEMBLYENGINE
2021 Ford Edge SE, 4WD
Section 635 (Engine - 3.3L DURATEC-V6): Assembly: Engine
2021 Ford Edge SE, 4WDSECTION Engine
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
For information on Ford Color Coded Illustrations refer to OEM COLOR CODING INFORMATION
Special Tool(s) / General Equipment
| 100-002 (TOOL-4201-C)Holding Fixture with Dial Indicator Gauge | |
|---|---|
| 205-142 (T80T-4000-J)Installer, Differential Bearing Cone | |
| 205-149 (T80T-4000-R)Installer, Spindle Bearing | |
| 205-153 (T80T-4000-W)Handle | |
| 303-102Installer, Crankshaft Pulley | |
| 303-1247VCT Spark Plug Tube Seal Remover and InstallerTKIT-2006UF-FLMTKIT-2006UF-ROW | |
| 303-1248Camshaft holding toolsTKIT-2006UF-FLMTKIT-2006UF-ROW | |
| 303-1250Seal Installer, Rear MainTKIT-2006UFFLM | |
| 303-1251Installer, Front SealTKIT-2006UF-FLMTKIT-2006UF-ROW | |
| 303-1530Tool, Chain Tensioner Hold DownTKIT-2010A-FTKIT-2010A-LMTKIT-2010A-ROW | |
| 303-1663Installer, VDOP Seal | |
| 303-335 (T88T-6701-A)Installer, Front Cover Oil SealTKIT-1988-FLMTKIT-1988-F | |
| 307-399Alignment Pins, Transmission Fluid PumpTKIT-2002N-DEWTKIT-2000AP-FLM/LM | |
| Feeler Gauge | |
| Floor Crane | |
| Mounting Stand | |
| Round-Ended Steel Rule | |
| Piston Ring Compressor |
Materials
| Name | Specification |
|---|---|
| Motorcraft® High Performance Engine RTV SiliconeTA-357 | WSE-M4G323-A6 |
NOTE:
During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces that enters the oil passages, coolant passages or the oil pan, may cause engine failure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.