Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Test G: B15DB:09
- Normal Operation and Fault Conditions
The starter motor electrical connection may be faulty, the solenoid switch engagement relay is faulty or the pinion gear or starter pinion or flywheel is damaged.
REFER to: Starter Motor Ground Circuit Check . REFER to: Starter Motor Voltage Circuit Check .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition BCM B15DB:09 Vehicle Starter Motor: Component Failures This DTC sets when a starter motor component failure or malfunction has been detected by the PCM. Possible Sources
- Starter motor or relay
- Starter motor ring gear
- Starter motor solenoid switch or coil
Visual Inspection and Pre-checks
- Starter motor cracked or damaged
- Damaged flexplate
Diagnostic steps are not provided for this symptom or DTC. REFER to: Diagnostic Methods
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.