SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 63 (PASSIVE ANTI-THEFT SYSTEM (PATS) - VEHICLES WITH: KEYLESS VEHICLE SYSTEM)DESCRIPTION AND OPERATIONPASSIVE ANTI-THEFT SYSTEM (PATS) - SYSTEM OPERATION AND COMPONENT DESCRIPTIONSYSTEM OPERATIONNO KEY DETECTED MESSAGE
2021 Ford Edge SE, 4WD

No Key Detected Message

2021 Ford Edge SE, 4WDSECTION No Key Detected Message
WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Some brands/types of mobile phone or laptop computer chargers may cause interference that could lead to a PATS concern if the passive key is within close proximity of the charger. If a concern is observed, move the passive key away from the charger and attempt to turn the ignition on.

There are 2 scenarios in which the No Key Detected message displays in the message center.

The first is when the ignition is off, the START/STOP button is pressed and a programmed passive key is not detected inside the vehicle. If a component failure (such as a depleted passive key batteries) is causing the No Key Detected message to display, the backup starting method can be used.

The second scenario is when the vehicle ignition is on, the driver exits the vehicle with the programmed passive key and closes the door.

The BCM activates the PATS center antenna, the PATS rear antenna and both exterior door handle keyless entry antennas to search the inside of the vehicle for a passive key any time a door is opened and then closed with the ignition on and the first time each drive cycle the vehicle speed exceeds 15 km/h (9 mph). The No Key Detected message displays in the message center and the horn chirps twice when the ignition is on and a passive key is no longer detected inside the vehicle.

This strategy deters the passive key from being separated from an already running vehicle. If a passive key is no longer in the vehicle, the ignition remains on and the vehicle continues to operate. When the START/STOP button is pressed to turn the ignition off, the ignition can be restarted without a passive key present inside the vehicle for approximately 20 seconds. After 20 seconds have elapsed, a passive key must be present to transition the ignition out of off.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.