SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 626 (ENGINE - 3.0L POWER STROKE DIESEL)REMOVAL AND INSTALLATIONFLEXPLATEINSTALLATION
2021 Ford Edge SE, 4WD

Removal And Installation: Flexplate: Installation

2021 Ford Edge SE, 4WDSECTION Installation
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the flexplate and the bolts. Tighten in sequence shown.

    Torque: Stage 1: 37 lb.ft (50 Nm)

    Stage 2: 45°

    Stage 3: 45°

    Fig 1: Flexplate Tightening Sequence
    GFD556093Courtesy of FORD MOTOR COMPANY
  2. Remove Special Service Tool: 303-1677 Locking Tool, Flywheel.
    GFD556003Courtesy of FORD MOTOR COMPANY
  3. Install the transmission.
  4. Road test the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.