SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 622 (ENGINE SYSTEM - GENERAL INFORMATION)GENERAL PROCEDURESRUN THE ENGINE
2021 Ford Edge SE, 4WD

Run the Engine

2021 Ford Edge SE, 4WDSECTION Run the Engine
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

For information on Ford Color Coded Illustrations refer to OEM COLOR CODING INFORMATION

Activation 

  1. Place the vehicle in PARK.
  2. Push the start button to enter the accessory mode.
  3. Press the brake pedal and accelerator pedal together for 5 seconds.
  4. Steps 5 and 6 should be performed within 15 seconds after completing Step 3.
  5. Release both the accelerator and brake pedals.
  6. Press the brake pedal and push the start button so that the vehicle is in drivable state.
  7. Press the brake pedal and accelerator pedal together for 5 seconds.
  8. When this sequence is complete, the vehicle enters the diagnostic mode and the engine should remain running continuously.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.