SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 610 (STEERING COLUMN)REMOVAL AND INSTALLATIONSTEERING COLUMNREMOVAL
2021 Ford Edge SE, 4WD

Steering Column: Removal

2021 Ford Edge SE, 4WDSECTION Removal
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation details.

All vehicles 

  1. Depower the SRS. Refer to: Supplemental Restraint System (SRS) Depowering .
  2. NOTE: This step is only necessary when installing a new component.

    Remove the SCCM. Refer to: Steering Column Control Module (SCCM) . Refer to: Steering Column Control Module (SCCM) - Vehicles With: Adaptive Steering .

  3. Remove the steering column shrouds. Refer to: Steering Column Shrouds .
  4. NOTE: Make sure that the steering wheel does not rotate or damage to the clockspring may occur.

    Secure the steering wheel.

    GFD552305Courtesy of FORD MOTOR COMPANY
  5. Remove the steering column opening lower trim panel.

    1. Unclip and lower the steering column opening lower trim panel.
    2. Remove the retainers and the steering column opening lower trim panel.

    GFD552306Courtesy of FORD MOTOR COMPANY
  6. Remove the steering column opening trim panel.
    GFD552307Courtesy of FORD MOTOR COMPANY

    Vehicles with selector lever 

  7. Remove the GSM. Refer to: Gear Shift Module (GSM) - Vehicles With: Column Shift .

    All vehicles 

  8. NOTE: Vehicles equipped with power adjustable steering column shown, all others similar.

    Includes deployable column connector. Disconnect the electrical connectors, release the retainers and position the wire harness aside.

    GFD552308Courtesy of FORD MOTOR COMPANY
  9. WARNING: Do not reuse steering column shaft bolts. This may result in fastener failure and steering column shaft detachment or loss of steering control. Failure to follow this instruction may result in serious injury to vehicle occupant(s).

    Disconnect the steering column upper shaft from the steering column.

    1. Remove and discard the bolt.

      Torque

      : 22 lb.ft (30 Nm)

    2. Disconnect the steering column upper shaft from the steering column.

    GFD552309Courtesy of FORD MOTOR COMPANY
  10. WARNING: Do not reuse steering column nuts. This may result in fastener failure and steering column detachment or loss of steering control. Failure to follow this instruction may result in serious injury to vehicle occupant(s).

    Remove and discard the retainers and remove the steering column.

GFD552310Courtesy of FORD MOTOR COMPANY
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.