SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 590 (CRUISE CONTROL - VEHICLES WITH: ADAPTIVE CRUISE CONTROL)REMOVAL AND INSTALLATIONCRUISE CONTROL MODULE (CCM)REMOVAL
2021 Ford Edge SE, 4WD

Cruise Control Module (CCM): Removal

2021 Ford Edge SE, 4WDSECTION Removal
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation details.

Cruise control module (CCM) 

  1. NOTE: If installing a new CCM (cruise control module), it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new CCM (cruise control module) after installation.

    Using a diagnostic scan tool, begin the PMI process for the CCM following the onscreen instructions.

  2. Release the clips and remove the CCM front bumper trim cover.
    GFD561139Courtesy of FORD MOTOR COMPANY
  3. Disconnect the CCM electrical connector.
    GFD561143Courtesy of FORD MOTOR COMPANY
  4. NOTE: The CCM (cruise control module) and base bracket shown removed for clarity.

    Remove the CCM.

    1. Release the CCM base bracket top clip.
    2. Slide the CCM up and out of the CCM base bracket.

    GFD561144Courtesy of FORD MOTOR COMPANY

    CCM (cruise control module) and base bracket 

  5. NOTE: If installing a new CCM (cruise control module), it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new CCM (cruise control module) after installation.

    Using a diagnostic scan tool, begin the PMI process for the CCM following the onscreen instructions.

  6. Remove the front bumper. Refer to: Front Bumper .
  7. Release the clips and remove the CCM front bumper trim cover.
    GFD561139Courtesy of FORD MOTOR COMPANY
  8. Disconnect the CCM electrical connector.
    GFD561143Courtesy of FORD MOTOR COMPANY
  9. Remove the CCM bolts and the CCM and base bracket.

    Torque

    : 80 lb.in (9 Nm)

GFD561145Courtesy of FORD MOTOR COMPANY
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.