Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Ignition Lock Cylinder: Removal
2021 Ford Edge SE, 4WDSECTION Removal
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
Non-functional lock cylinder
NOTE:
For non-functional ignition lock cylinders, replace the ignition lock cylinder housing.
- Remove the ignition switch. Refer to: Ignition Switch - Vehicles With: Keyed Ignition
.
Functional lock cylinder
NOTE: Repair individual lock cylinders by discarding the inoperative lock cylinder and building a new lock cylinder using the appropriate lock repair service kit. The lock repair service kit includes a detailed instruction sheet to build the new lock to match the key cut pattern for the vehicle, thus allowing for single point replacement without needing to replace or reprogram other locks or keys. - Release the clips and remove the upper finish trim panel.
- Release the clips and remove the center finish trim panel.
- Remove the ignition lock cylinder.
- Insert the ignition key and position the ignition lock cylinder to the ACC position.
- Using a suitable tool, press the ignition lock cylinder release pin through the access hole. Use the General Equipment: Pick Hook
- Pulling the ignition lock cylinder outward, remove the ignition lock cylinder.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.