Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 583 (HYDRAULIC BRAKE ACTUATION)
2021 Ford Edge SE, 4WD
Section 583 (Hydraulic Brake Actuation)
2021 Ford Edge SE, 4WDSECTION Section 583 (Hydraulic Brake Actuation)
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Description And Operation
- Diagnosis And Testing
- Hydraulic Brake Actuation
- Diagnostic Trouble Code (DTC) Chart
- Global Customer Symptom Code (GCSC) Chart
- Symptom Charts
- Pinpoint Tests
- Pinpoint Test A: Adjustable Pedals Are Inoperative Or Do Not Operate Correctly - Without Memory Feature
- Pinpoint Test B: Adjustable Pedals Are Inoperative Or Do Not Operate Correctly - Using The Adjustable Pedal Control Switch (With Memory Feature)
- Pinpoint Test C: Adjustable Pedals Are Inoperative Or Do Not Operate Correctly - Using The Memory Set Switch Buttons Or The RKE (Remote Keyless Entry) Transmitter
- Pinpoint Test D: B1368:11, B1368:15
- Pinpoint Test E: Adjustable Pedal Only Move For 2 Seconds Regardless Of How Long The Adjustable Pedal Control Switch Is Pressed
- Hydraulic Brake Actuation
- General Procedures
- Removal And Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.