Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Anti-Lock Brake System (ABS) Module: Installation
2021 Ford Edge SE, 4WDSECTION Installation
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
-
NOTE: Make sure that the ABS module is aligned correctly before installing the module screws or damage to the ABS module or EBB may occur.
To install, reverse the removal procedure.
- Using a diagnostic scan tool, complete the PMI process for the ABS module following the on-screen instructions.
- Carry out the ABS Calibration service function using the scan tool and following the diagnostic scan tool on-screen instructions.
- Run the PCMPATS programming application and then carry out the Module Initialization (Parameter Reset) using the scan tool and following the scan tool on-screen instructions.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.