Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Test K: U3001:68: Notes
Normal Operation and Fault Conditions
This DTC is for informational purposes only and sets in conjunction with other ABS module Diagnostic Trouble Codes (DTCs). Retrieve and diagnose all other ABS module Diagnostic Trouble Codes (DTCs).
REFER to: Anti-Lock Brake System (ABS) and Stability Control - System Operation and Component Description .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Condition |
|---|---|---|
| ABS U3001:68 | Control Module Improper Shutdown Performance: Event Information | This DTC sets when the ABS module has not shut down properly. This is usually due to a loss of power before the module has shut down, such as a low battery or open circuit. |
Possible Sources
- Low battery voltage
- Open circuit or fuse
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.